kascemobi.blogg.se

1. Renesas usb 3.0 driver windows 10 error code 24 how to#
2. Renesas usb 3.0 driver windows 10 error code 24 driver#

Again, the vendor utility is working no problem.

Renesas usb 3.0 driver windows 10 error code 24 how to#

I wonder if there is a secret sauce that you know about, how to get OpenOCD connect to an STM32 board that has a built-in ST-Link v2.1, or if it is known to be flaky and maybe I should not waste my time on it. I went one step farther and installed a standalone version of OpenOCD to no avail, still not working, so the problem is not with Eclipse. Still, OpenOCD in Eclipse fails to see the board, while ST-Link can. I checked and made sure the board's USB PID/VID in Windows are the same as in the OpenOCD script files, and they also can be seen in the attached log, all is matching. This only occurs when I connect a new WD My Passport external HD and connect it to the SS3.0 port.

Renesas usb 3.0 driver windows 10 error code 24 driver#

I've tried updating the driver to no avail. When I go to Device Manager it says that it's a Code 24. So the board and the USB link is operational. The Renesas USB 3.0 eXtensible Host Controller - 0.95 Microsoft is not working. I tried multiple USB cables, I fiddled with the auto-start switch on my scanner, I tried using power over USB and power from the wall, I tried changing which port the USB was plugged into on the computer (front ports, back ports, USB 2.0, USB 3.0, USB 1.0), I tried unplugging other USB devices to decrease the number of devices on the bus, I.

Code: Debug: 258 166 hla_layout.c:42 hl_layout_open(): hl_layout_open Debug: 259 169 stlink_usb.c:1698 stlink_usb_open(): stlink_usb_open Debug: 260 169 stlink_usb.c:1716 stlink_usb_open(): transport: 1 vid: 0x0483 pid: 0x374b serial: Error: 261 207 stlink_usb.c:1729 stlink_usb_open(): open failed Debug: 262 207 hla_layout.c:49 hl_layout_open(): failed Debug: 263 208 command.c:628 run_command(): Command failed with error code -4 User : 264 208 command.c:689 command_run_line(): in procedure 'init' in procedure 'ocd_bouncer' Now, I also downloaded the ST-Link programming utility from ST and when I run it, it is working, it finds the board no problem.